Close
0 items
You have no items in your shopping cart.
OUR LED PRODUCTS
    Filters
    Preferences
    Search

    LED RGB CLIPTIGHT Jumper

    $4.95
    LED RGB CLIPTIGHT Jumper is easy to use with LED RGB Tape Light systems. The 10mm Power Clip Jumper allows the LED RGB tape light to insert into the connector and seat properly under the terminals. Solderless clip connectors allow for easy configuration of your LED RGB Tape Lighting system.
    SKU: STVO12J-RGB-10

    Step 1 Dezigns LED RGB CLIPTIGHT Jumper fits 5050 RGB LED Tape Lights with a 10mm width, 4-pin connection on each end. The connector ends of the jumper are made from PBT heat resistant material, it protects the led strip from high temperature. No screw terminals, simply slide in the tape light and clamp down. 

    Installation Instructions: 

    1.  Open the clips on each side
    2.  Slide the 10mm LED RGB tape light inside each clip underneath the contact prongs
    3. Make sure the side of the LED Tape light aligns with the "+ -" polarity
    4. Close the connector clips
    *
    *
    *

    Step 1 Dezigns LED RGB CLIPTIGHT Jumper fits 5050 RGB LED Tape Lights with a 10mm width, 4-pin connection on each end. The connector ends of the jumper are made from PBT heat resistant material, it protects the led strip from high temperature. No screw terminals, simply slide in the tape light and clamp down. 

    Installation Instructions: 

    1.  Open the clips on each side
    2.  Slide the 10mm LED RGB tape light inside each clip underneath the contact prongs
    3. Make sure the side of the LED Tape light aligns with the "+ -" polarity
    4. Close the connector clips